Engineering Center

Client has requested the ASTM E488 test report for Hilti HIT-RE 500 V4 in order to complete the MAR (Material Approval Request) process. The end user of the project is Saudi Aramco, and this document is one of their mandatory technical submission requirements.

Client has requested the ASTM E488 test report for Hilti HIT-RE 500 V4 in order to complete the MAR (Material Approval Request) process. The end user of the project is Saudi Aramco, and this document is one of their mandatory technical submission requirements.

Client has requested the ASTM E488 test report for Hilti HIT-RE 500 V4 in order to complete the MAR (Material Approval Request) process. The end user of the project is Saudi Aramco, and this document is one of their mandatory technical submission requirements.

I am trying to consider HST4 M16x145 as this is the available length to order as per procurement. But this anchor length is not showing on HILTI profis software. How can I show this so that I can match it in the drawings?

What anchor can I use for a gypsum wall? I have a shear load of around 4kN for that connection.

Hi, In the HILTI technical data sheet for HIT HY 270 Injectable anchor mortar for masonry, the partial safety factor used for injection anchor is 2.5. However, according to the Eurocode, the material factor for anchor design only 1.25; so the use of 2.5 in Hilti data sheet is that because 2.5 include both material factor and ...

I need to provide grouting for about 30 mm instead of packing for the brackets .what is the restraint value i need to give. what are the solution to be considered if the steel failed due to the 30 mm grout?

Dear Support, While clicking the Save and Generate in the Generate Report Page we are getting the below error. Calling web service signalr-service failed. Unsupported area Common.Units.Unit. Please try again later. If the problem persists contact us at ae.technicalsupport@hilti.com Please help to solve this issue. Thanks...

we usualy use this type of connection in seismic resisting model

Hi, I am trying to select depth for HST2 type Bolt but it is not giving option as per available depth. As per website available depths are from 75 to 170mm but this option is not giving in software. Regards Mohammad Moeen 0557202471