Engineering Center

we have account under Air Products Chemicals, Inc. with Kevin Tieman. my email Hussieh@Airproducts.com my work number 610481-3552, I am available on Microsoft team as well.

A load of 28N and a bending moment of 9N.m are applied on the side of a plate of 100x75mm. The plate is 500mm long and only one anchor is set at the middle of the plate on the side 100x500mm. Please let me know which anchor would be appropriate for this arrangement.

How do I change rebar spacing and embedment depth for post-installed rebar?

How to change plate design from CBFEM to Rigid?

I want to know how to change the registered email address on my account?

how do i enter dynamic load on HILTI Profis

There is a requirement of using paired channel on top where the Profis Anchor Channel software is not allowing since the icon is dimmed with all standards. In order to model this case, I have used one single channel with edge distance equal to the edge distance of the first channel close to the edge plus half the spacing betwe...

Dear HILTI Support Team, I hope this message finds you well. I am currently working on a pedestrian bridge project where we have specified the use of a maximum of 30mm grout below the bottom attachment plate. However, the contractor has suggested substituting the specified grout with HIT-RE 500 injection mortar for this applic...

How can i get rid of the error to provide a profile and create report

I was trying to get my CEU for Beyond Bond Strength: Temperature Considerations for Adhesive Anchors - certificate